Tire Pressure Monitor Receiver / Transponder: Service and Repair

TIRE PRESSURE WARNING RECEIVER (w/ Antenna)

COMPONENTS (Part 1):

COMPONENTS (Part 2):

COMPONENTS (Part 3):

COMPONENTS (Part 4):

COMPONENTS (Part 5):

REMOVAL
1. DISCONNECT BATTERY NEGATIVE TERMINAL
(a) Disconnect the negative terminal.
2. REMOVE REAR NO. 2 SEAT LH
3. REMOVE REAR NO. 2 SEAT RH

HINT: Remove the RH side following the same procedures as with the LH side.

4. REMOVE ROOF HEADLINING ASSEMBLY

HINT: Refer to the instruction for removal of the roof headlining assembly.





5. REMOVE TIRE PRESSURE WARNING ANTENNA AND RECEIVER
(a) Disconnect the connector.
(b) Remove the 2 bolts and receiver assembly.

INSTALLATION





1. INSTALL TIRE PRESSURE WARNING ANTENNA AND RECEIVER
(a) Install the receiver assembly with the 2 bolts.
Torque: 6.8 N*m (69 kgf*cm, 60 in.*lbf)
(b) Connect the connector.
2. INSTALL ROOF HEADLINING ASSEMBLY

HINT: Refer to the instruction for removal of the roof headlining assembly.

3. INSTALL REAR NO. 2 SEAT LH
4. INSTALL REAR NO. 2 SEAT RH
5. CONNECT BATTERY NEGATIVE TERMINAL
6. REGISTRATION OF TRANSMITTER ID