Component Tests and General Diagnostics
INSPECTION1. INSPECT FRONT SEAT INNER BELT ASSEMBLY LH
a. Inspect the buckle switch.
1. Fasten the seat belt (Buckle switch is ON).
2. Check the continuity or resistance between the terminals.
3. Release the seat belt (Buckle switch is OFF).
4. Check the continuity or resistance between the terminals.
If the result is not as specified, replace the inner belt assembly.
b. Inspect the circuit for the airbag seat position sensor.
1. Check the continuity between the terminals of connector A and the connector of the airbag seat position sensor.
If the result is not as specified, replace the inner belt assembly.
2. INSPECT FRONT SEAT INNER BELT ASSEMBLY RH
a. Inspect the buckle switch.
1. Short the circuit between connector terminals 1 and 3 of the occupation detection sensor (Seat is occupied).
2. Fasten the seat belt (Buckle switch is ON).
3. Check the continuity between the terminals.
4. Release the seat belt (Buckle switch is OFF).
5. Check the continuity between the terminals.
If the result is not as specified, replace the inner belt assembly.
b. Inspect the buckle switch.
1. Disconnect the occupation detection sensor connector (Seat is not occupied).
2. Fasten the seat belt (Buckle switch is ON).
3. Check the continuity between the terminals.
4. Release the seat belt (Buckle switch is OFF).
5. Check the continuity between the terminals.
If the result is not as specified, replace the inner belt assembly.