Steering Angle Sensor: Service and Repair
REMOVAL1. PRECAUTION
2. DISCONNECT BATTERY NEGATIVE TERMINAL
3. PLACE FRONT WHEELS FACING STRAIGHT AHEAD
4. REMOVE STEERING WHEEL COVER LOWER NO. 3
5. REMOVE STEERING WHEEL COVER LOWER NO. 2
6. REMOVE STEERING PAD
7. REMOVE STEERING WHEEL ASSEMBLY
8. REMOVE STEERING COLUMN COVER
9. REMOVE SPIRAL CABLE
10. REMOVE TURN SIGNAL SWITCH ASSEMBLY
11. REMOVE STEERING ANGLE SENSOR
a. Remove the steering sensor connector.
b. Remove the 2 claws, then remove the steering sensor.
INSTALLATION
1. INSTALL STEERING ANGLE SENSOR
a. Install the steering sensor.
b. Install the steering sensor connector.
2. INSTALL TURN SIGNAL SWITCH ASSEMBLY
3. INSPECT SPIRAL CABLE
4. PLACE FRONT WHEELS FACING STRAIGHT AHEAD
5. INSTALL SPIRAL CABLE
6. INSTALL STEERING COLUMN COVER
7. INSTALL STEERING WHEEL ASSEMBLY
8. INSTALL STEERING PAD
9. INSTALL STEERING WHEEL COVER LOWER NO. 2
10. INSTALL STEERING WHEEL COVER LOWER NO. 3
11. INSPECT SRS WARNING LIGHT
12. PERFORM STEERING ANGLE SENSOR ZERO POINT CALIBRATION
13. CHECK VSC SENSOR SIGNAL