Front Speed Sensor
REMOVALHINT: Replacement of RH side is same as that of LH side.
1. REMOVE FRONT WHEEL
2. REMOVE SPEED SENSOR FRONT LH
a. Disconnect the speed sensor connector.
b. Using a hexagon wrench (5 mm), remove the bolt and front speed sensor from the steering knuckle.
NOTE:
- Do not stick and foreign matter on the sensor tip.
- Do not let the foreign matter into the sensor installation hole.
INSTALLATION
1. INSTALL SPEED SENSOR FRONT LH
a. Using a hexagon wrench (5 mm), install the front speed sensor with the bolt to the steering knuckle.
Torque: 8.3 N.m (85 kgf.cm, 73 in.lbf)
NOTE: Make sure the sensor tip is clean.
b. Connect the speed sensor connector.
2. INSTALL FRONT WHEEL
Torque: 112 N.m (1,142 kgf.cm, 83 ft.lbf)
3. CHECK VSC SENSOR SIGNAL