Operation CHARM: Car repair manuals for everyone.
Home >> Lexus Truck >> 2007 >> GX 470 V8-4.7L (2UZ-FE) >> Repair and Diagnosis >> Sensors and Switches >> Sensors and Switches - Restraints and Safety Systems >> Impact Sensor >> Service and Repair >> Center Airbag Sensor Assembly

Center Airbag Sensor Assembly

Center Airbag Sensor Assembly:




CENTER AIRBAG SENSOR ASSEMBLY

REMOVAL

1. PRECAUTION

CAUTION: Be sure to read "PRECAUTION" thoroughly before servicing (Refer to Restraint Systems Service Precautions).

2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
3. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY
4. REMOVE CONSOLE UPPER PANEL GARNISH NO. 1
5. REMOVE CONSOLE UPPER PANEL GARNISH NO. 2
6. REMOVE CONSOLE PANEL UPPER ASSEMBLY
7. REMOVE CONSOLE REAR END PANEL SUB-ASSEMBLY
8. REMOVE REAR CONSOLE BOX ASSEMBLY
9. REMOVE CONSOLE BOX INSERT FRONT NO. 2
10. REMOVE CONSOLE BOX INSERT
11. REMOVE CONSOLE UPPER PANEL GARNISH FRONT
12. REMOVE CONSOLE BOX LOWER
13. REMOVE CENTER AIRBAG SENSOR ASSEMBLY




a. Disconnect the 3 connectors from the center airbag sensor assembly.
b. Remove the 3 bolts and the center airbag sensor assembly.

INSTALLATION

1. INSTALL CENTER AIRBAG SENSOR ASSEMBLY
a. Check that the ignition switch is off.
b. Check that the battery negative (-) terminal is disconnected.

CAUTION: After disconnecting the negative battery terminal, wait for at least 90 seconds before starting the operation.




c. Temporarily install the center airbag sensor assembly with the 3 bolts.

NOTE:
- If the center airbag sensor assembly has been dropped, or there are any cracks, dents or other defects in the case, bracket or connector, replace it with a new one.
- When installing the center airbag sensor assembly, be careful that the SRS wiring does not interfere with other parts and that it is not pinched between other parts.

d. Tighten the 3 bolts to the specified torque.

Torque: 17.5 N.m (179 kgf.cm, 13 ft.lbf)

e. Check that there is no looseness in the installation parts of the center airbag sensor assembly.
f. Connect the 3 connectors to the center airbag sensor assembly.
g. Check that the waterproof sheet is properly set.

2. INSTALL CONSOLE BOX LOWER
3. INSTALL CONSOLE UPPER PANEL GARNISH FRONT
4. INSTALL CONSOLE BOX INSERT
5. INSTALL CONSOLE BOX INSERT FRONT NO. 2
6. INSTALL REAR CONSOLE BOX ASSEMBLY
7. INSTALL CONSOLE REAR END PANEL SUB-ASSEMBLY
8. INSTALL CONSOLE PANEL UPPER ASSEMBLY
9. INSTALL CONSOLE UPPER PANEL GARNISH NO. 2
10. INSTALL CONSOLE UPPER PANEL GARNISH NO. 1
11. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY
12. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
13. INSPECT SRS WARNING LIGHT
a. Inspect the SRS warning light.
pro multis · About Operation CHARM