Seat Position Sensor: Service and Repair

Seat Position Sensor:

SEAT POSITION SENSOR

REMOVAL

1. PRECAUTION

CAUTION: Be sure to read "PRECAUTION" thoroughly before servicing. (Refer to Restraint Systems Service Precautions).

2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION: Wait for 90 seconds after disconnecting the cable to prevent the airbag working.

3. REMOVE SEAT TRACK BRACKET COVER OUTER FRONT LH
4. REMOVE SEAT TRACK BRACKET COVER INNER FRONT LH
5. REMOVE SEAT TRACK COVER LH
6. REMOVE SEAT TRACK COVER RH
7. REMOVE FRONT SEAT ASSEMBLY LH
8. REMOVE SEAT POSITION AIRBAG SENSOR




a. Disconnect the connector from the seat position sensor.
b. Remove the bolt and seat position sensor.

INSTALLATION

1. INSTALL SEAT POSITION AIRBAG SENSOR
a. Check that the ignition switch is off.
b. Check that the negative battery (-) terminal is disconnected.

CAUTION: After disconnecting the negative battery terminal, wait for at least 90 seconds before starting the operation.




c. Install the seat position sensor with a new bolt.

Part Number: Bolt: 90119-06871

Torque: 8.0 N.m (82 kgf.cm, 71 in.lbf)

d. Check that there is no looseness in the installation parts of the seat position sensor.
e. Connect the connector to the seat position sensor.

2. INSTALL FRONT SEAT ASSEMBLY LH
3. INSTALL SEAT TRACK COVER RH
4. INSTALL SEAT TRACK COVER LH
5. INSTALL SEAT TRACK BRACKET COVER INNER FRONT LH
6. INSTALL SEAT TRACK BRACKET COVER OUTER FRONT LH
7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
8. INSPECT SRS WARNING LIGHT
a. Inspect the SRS warning light.