Fuel Lid Opener Switch Circuit

ENGINE HOOD / DOOR: FUEL LID OPENER SYSTEM: Fuel Lid Opener Switch Circuit

Fuel Lid Opener Switch Circuit

DESCRIPTION

The hybrid vehicle control ECU detects the condition of the fuel lid opener switch.

WIRING DIAGRAM





INSPECTION PROCEDURE

PROCEDURE

1. READ VALUE OF TECHSTREAM
(a) Connect Techstream to the DLC3.
(b) Turn the ignition switch to the ON position and turn the tester on.
(c) Select Fuel Lid Switch in the Data List and read the tester display.






OK:
ON or OFF appears on the screen according to the switch condition.
NG -- INSPECT FUEL LID OPENER SWITCH
OK -- PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE
2. INSPECT FUEL LID OPENER SWITCH





(a) Remove the fuel lid opener switch.
(b) Measure the resistance according to the value(s) in the table below.
Standard resistance:






NG -- REPLACE FUEL LID OPENER SWITCH
OK -- Continue to next step.
3. CHECK HARNESS AND CONNECTOR (FUEL LID OPENER SWITCH - HYBRID VEHICLE CONTROL ECU)





(a) Disconnect the H29 ECU connector.
(b) Measure the resistance according to the value(s) in the table below.
Standard resistance:






NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR
OK -- Continue to next step.
4. CHECK HARNESS AND CONNECTOR (FUEL LID OPENER SWITCH - BODY GROUND)





(a) Measure the resistance according to the value(s) in the table below.
Standard resistance:






NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR
OK -- PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE