Body - Power Back Door Initialization Procedure

PRE-DELIVERY SERVICE
PD048-07

Title:
INITIALIZATION OF POWER BACK DOOR DURING PDS

Models:
'08 RX 400h

August 25, 2007

Introduction:
As a result of the removal of the Short Pin, the "automatic open and close" and "jam protection" functions of the power back door will be inoperative due to loss of the power back door position memory stored in the microcomputer.

Initialize the power back door after installing the Short Pin in its original location during Pre-Delivery Service (PDS).





NOTE:

^ To install the Short Pin, refer to TSIB No. PD046-07, "Short Pin & Engine Compartment Side Cover Installation During PDS".

^ Any time the battery terminal has been disconnected, the power back door MUST be re-initialized.

Applicable Vehicles

^ 2008 model year RX 400h vehicles.





Warranty Information

Initialization Procedure

1. Fully close the power back door.

2. Cycle the power back door to the fully open and the fully closed position.

A. Unlock the power back door using the "UNLOCK" button on the transmitter switch or the door control switch.

B. Check that the ignition switch is in the OFF position, and make sure the power back door off switch is in the ON position.





C. Fully open and fully close the power back door by pushing the power back door switch (open/close) or the "PWR DOOR" button briefly on the transmitter switch.

NOTE:
Jam protection function is enabled through the above initialization procedure.