Installation

SLIDING ROOF: SLIDING ROOF HOUSING:

INSTALLATION

1. INSTALL SLIDING ROOF HOUSING SUB-ASSEMBLY






(a) Install the sliding roof housing sub-assembly with the 4 bolts and 8 nuts.






(b) Connect the 4 sliding roof drain hoses.
NOTE: The clip must face toward the exterior of the vehicle when installing the drain hoses.

2. INSTALL SLIDING ROOF GLASS SUB-ASSEMBLY






(a) Using a T25 "torx" socket wrench, temporarily install the sliding roof glass sub-assembly with the 4 screws.
(b) Perform a level check.





(1) Check the difference in level for "a" between the roof panel and roof glass when the sliding roof glass is fully closed.
Standard:





HINT: "+" represents the condition that the glass is above the panel level. "-" represents the condition that the glass is below the panel level.

(c) Perform a gap check.





(1) Check the gap between the roof panel and roof glass.
NOTE: The gap must be even all around.

(d) After adjusting the sliding roof glass, using a T25 "torx" socket wrench, install the sliding roof glass sub-assembly with the 4 screws.
3. INSPECT FOR WATER LEAK
(a) After adjusting the sliding roof glass sub-assembly, check for water leaks.
(b) If there are any leaks, readjust the sliding roof glass sub-assembly.
4. INSTALL SLIDING ROOF SIDE LH GARNISH






(a) Engage the 5 claws and install the sliding roof side garnish.
5. INSTALL SLIDING ROOF SIDE RH GARNISH
6. INSTALL TELEVISION DISPLAY BRACKET (w/ Rear Seat Entertainment System)
(a) Install the television display bracket with the 4 bolts.
7. INSTALL CURTAIN SHIELD LH AIRBAG ASSEMBLY Installation

8. INSTALL CURTAIN SHIELD RH AIRBAG ASSEMBLY
9. INSTALL ROOF HEADLINING ASSEMBLY
Installation
10. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
11. PERFORM INITIALIZATION Repair Instruction - Initialization

12. INSPECT SLIDING ROOF SYSTEM
On-Vehicle Inspection
13. INSPECT SLIDE ADJUSTER LOCK Installation