Installation

BRAKE: REAR BRAKE:

INSTALLATION

1. INSTALL REAR DISC BRAKE CYLINDER ASSEMBLY






(a) Install the rear disc brake cylinder assembly.
NOTE: Install the rear disc brake bush dust boot onto the groove of the rear disc brake cylinder.

2. INSTALL REAR DISC BRAKE CYLINDER SLIDE PIN NO.1
(a) Apply the lithium soap base glycol grease to the sliding part and the seal surface of the slide pin.






(b) Install the rear disc brake cylinder slide pin No.1.
Torque: 43 Nm (440 kgf-cm, 32 ft-lbf)
3. INSTALL REAR DISC BRAKE CYLINDER SLIDE PIN NO.1
(a) Apply the lithium soap base glycol grease to the sliding part and the seal surface of the slide pin No.2.
(b) Install the rear disc brake cylinder slide pin No.2.
Torque: 43 Nm (440 kgf-cm, 32 ft-lbf)
4. CONNECT REAR FLEXIBLE HOSE
(a) Connect the flexible hose with the union bolt and a new gasket.
Torque: 29 Nm (300 kgf-cm, 21 ft-lbf)
5. ADD RESERVOIR WITH BRAKE FLUID Service and Repair

6. BLEED REAR BRAKE SYSTEM Service and Repair

7. PERFORM ACCUMULATOR ZERO DOWN Service and Repair

8. CHECK BRAKE FLUID LEVEL Service and Repair

9. INSPECT FOR BRAKE FLUID LEAK
10. INSTALL REAR WHEEL
Torque: 103 Nm (1,050 kgf-cm, 76 ft-lbf)
11. CLEAR DTC
Reading and Clearing Diagnostic Trouble Codes