Data List / Active Test

P310 HYBRID BATTERY CONTROL: HYBRID BATTERY SYSTEM:

DATA LIST / ACTIVE TEST

1. DATA LIST
NOTICE:
- The DATA LIST values may vary significantly if there are slight differences in measurement, differences in the environment in which the measurements are obtained, or the aging of the vehicle. Thus, definite standards or judgment values are unavailable. Therefore, there may be a malfunction even if a measured value is within the reference range.
- In the event of intricate symptoms, collect sample data from another vehicle of the same model operating under identical conditions in order to reach an overall judgment by comparing all the items of DATA LIST.
HINT: Using the DATA LIST displayed on the hand-held tester, you can read the values including those of the switches, sensors, actuators, without removing any parts. Reading the DATA LIST as the first step of troubleshooting is one method to shorten diagnostic time.

(a) Connect Techstream to the DLC3.
(b) Turn the ignition switch to the ON position and turn Techstream on.
(c) Select the following menu items: Powertrain / Hybrid Control / Trouble Codes.
HINT: For the DATA LIST Data List / Active Test.

2. ACTIVE TEST
NOTE: Beware that if the connector to Techstream becomes disconnected or if a communication error occurs during the ACTIVE TEST, the vehicle could become inoperative (the READY light goes off).
HINT: Performing an ACTIVE TEST using the hand-held tester enables components including the relay, VSV, and actuator, to be operated without removing any parts. Performing an ACTIVE TEST as the first step of troubleshooting is one method to shorten diagnostic time.

(a) Connect the Techstream to the DLC3.
(b) Turn the ignition switch to the ON position and turn Techstream on.
(c) Select the following menu items: Powertrain / Hybrid Control / Active Test.
HINT: For the active test chart Data List / Active Test.