Canada - Windows - Initialization of Power Window
BulletinTSB2503
Issue Date
September 17, 2007
Title
INITIALIZATION OF POWER WINDOW DURING PDS
Component
GENERAL INFORMATION
Models
'08 RX 400h
INTRODUCTION:
During Pre-Delivery Service (PDS), initialize each door's power window after installing the Short Pin in its original location.
The installation of the Short Pin will enable the "one-touch open and close" and "jam protection" functions of each door's power window.
NOTE:
Any time the battery terminal has been disconnected, each door's power window MUST be initialize after reconnecting the battery terminal.
APPLICABLE VEHICLES:
- 2008 model year RX 400h vehicles.
WARRANTY INFORMATION:
INITIALIZATION PROCEDURE:
With ignition switch in the "ON" position, do the following:
NOTE:
If the power windows have not been initialized, the driver's door power window switch should be blinking.
1. Push the driver's door power window switch to open the window.
2. Pull up the driver's door power window switch until the window closes, and hold it for approximately one second. At this time, the driver's door power window switch illumination changes from blinking to constant illumination.
NOTE:
- To initialize the other 3 passenger windows, press the switch on each passenger door to open the windows. Then pull up each door's power window switch until the window closes, and hold it for approximately one second.
- At this time, each door's power window switch illumination changes from blinking to constant illumination.
3. Check for proper operation of the "one-touch open and close" function by fully pushing the switch "DOWN" once and fully pulling the switch "UP" once.
NOTE:
Jam protection function is enabled through the above initialization procedure.