Power Back Door Opener/Closer Switch Circuit

ENGINE HOOD / DOOR: POWER BACK DOOR SYSTEM: Power Back Door Opener / Closer Switch Circuit

Power Back Door Opener / Closer Switch Circuit

DESCRIPTION

The power back door opener/closer switch only turns on while the switch is being pressed, and turns off when the switch is released.
The body ECU is connected to the power back door opener/closer switch via terminal PBDS and power back door operation request signals are input to the ECU.
The body ECU applies voltage to the power back door opener/closer switch via terminal PBDS. When the switch is on (there is continuity between the switch terminals), a power back door operation request signal is input to the body ECU to operate the back door.
NOTE: The power back door ECU records the back door positions in the memory. In the case where any of the batteries, fuses, power back door ECU and power back door drive unit are removed and then reinstalled, the power back door ECU loses the memory of the door positions. In such a case, resetting the power back door system is necessary. Refer to the resetting operation Initialization.

WIRING DIAGRAM





INSPECTION PROCEDURE

PROCEDURE

1. READ VALUE OF DATA LIST (POWER BACK DOOR OPENER/CLOSER SWITCH)
(a) Check the DATA LIST to ensure proper function of the power back door opener/closer switch.

Main Body (Body ECU):





OK:
The display is as specified in the normal condition.
NG -- INSPECT POWER BACK DOOR OPENER/CLOSER SWITCH ASSEMBLY
OK -- PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE
2. INSPECT POWER BACK DOOR OPENER/CLOSER SWITCH ASSEMBLY





(a) Remove the power back door opener/closer switch assembly.
(b) Measure the resistance according to the value(s) in the table below.
Standard resistance:






NG -- REPLACE POWER BACK DOOR OPENER /CLOSER SWITCH ASSEMBLY
OK -- Continue to next step.
3. CHECK WIRE HARNESS (POWER BACK DOOR OPENER/CLOSER SWITCH - POWER BACK DOOR ECU)





(a) Disconnect the power back door opener/closer switch assembly connector.
(b) Disconnect the instrument panel J/B connector.
(c) Measure the resistance according to the value(s) in the table below.
Standard resistance:






NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR
OK -- PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE