Pinout Values and Diagnostic Parameters

MIRROR: POWER MIRROR CONTROL SYSTEM (w/ Memory):

TERMINALS OF ECU

1. CHECK OUTER MIRROR CONTROL ECU LH





(a) Disconnect the R27 connector.
(b) Measure the voltage and resistance according to the value(s) in the table below.
Standard voltage:






Standard resistance:





If the result is not as specified, there may be a malfunction on the wire harness side.
(c) Reconnect the R27 connector.
(d) Measure the voltage according to the value(s) in the table below.
Standard voltage:






2. CHECK OUTER MIRROR CONTROL ECU RH





(a) Disconnect the R28 connector.
(b) Measure the voltage and resistance according to the value(s) in the table below.
Standard voltage:






Standard resistance:





If the result is not as specified, there may be a malfunction on the wire harness side.
(c) Reconnect the R28 connector.
(d) Measure the voltage according to the value(s) in the table below.
Standard voltage: