Removal

P310 HYBRID TRANSMISSION / TRANSAXLE: HYBRID VEHICLE TRANSAXLE:

REMOVAL

1. REMOVE ENGINE ASSEMBLY WITH HYBRID VEHICLE TRANSAXLE
Removal
2. REMOVE MANIFOLD STAY Removal

3. REMOVE HYBRID VEHICLE TRANSAXLE MASS DAMPER Removal

4. REMOVE FRONT FRAME ASSEMBLY Removal

5. REMOVE FRONT DRIVE SHAFT ASSEMBLY LH Removal

6. REMOVE FRONT DRIVE SHAFT ASSEMBLY RH Removal

7. REMOVE FLYWHEEL HOUSING UNDER COVER






(a) Remove the 2 bolts and flywheel housing under cover.
8. SEPARATE ENGINE WIRE
(a) Remove the bolt and ground wire.
(b) Disconnect the wire harnesses from the clamps.
(c) Disconnect the connectors.









(d) Remove the 4 bolts and 4 clamps.
9. REMOVE AUTOMATIC TRANSMISSION CASE COVER






(a) Remove the bolt and clamp.
(b) Remove the bolt, clip and case cover from the hybrid transaxle.
10. REMOVE WATER HOSE






(a) Disconnect the water hose from the hybrid transaxle.
11. REMOVE FRONT ENGINE MOUNTING BRACKET






(a) Remove the 3 bolts and engine mounting bracket.
12. REMOVE OIL COOLER INLET TUBE SUB-ASSEMBLY (w/ Oil Cooler)
(a) Remove the bolt and oil cooler tube clamp.
(b) Using SST and a wrench, disconnect the oil cooler inlet tube.
SST: 09023-12701
13. REMOVE OIL COOLER OUTLET TUBE SUB-ASSEMBLY (w/ Oil Cooler)
(a) Using SST and a wrench, disconnect the oil cooler outlet tube.
SST: 09023-12701
(b) Remove the bolt and oil cooler tube bracket.
14. REMOVE NO. 1 TRANSMISSION CONTROL CABLE BRACKET
(a) Remove the 2 bolts and No.1 transmission control cable bracket.
15. REMOVE HYBRID VEHICLE TRANSAXLE ASSEMBLY






(a) Remove the 8 bolts.
(b) Separate and remove the hybrid vehicle transaxle.
NOTE: Do not pry between the transaxle assembly and engine more than necessary to prevent the knock pins from being damaged.