Up to 08/2009
NETWORKING: LIN COMMUNICATION SYSTEM: B1273: Sliding Roof ECU Communication Stop
B1273 - Sliding Roof ECU Communication Stop
DESCRIPTION
This DTC is stored when LIN communication between the sliding roof ECU (sliding roof drive gear assembly) and main body ECU (multiplex network body ECU) stops for more than 10 seconds.
WIRING DIAGRAM
INSPECTION PROCEDURE
NOTICE:
* When the sliding roof ECU (sliding roof drive gear assembly) is replaced or removed and reinstalled, it requires initialization Initialization.
* When using the Techstream to troubleshoot with the engine switch off:
* Connect the Techstream to the DLC3, and turn the courtesy switch on and off at 1.5-second intervals until communication between the Techstream and vehicle begins.
PROCEDURE
1. INSPECT INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY
(a) Remove the instrument panel junction block assembly Removal.
(b) Remove the main body ECU (multiplex network body ECU) from the instrument panel junction block assembly.
(c) Measure the resistance according to the value(s) in the table below.
HINT
This inspection is to check the LIN line in the instrument panel junction block assembly that connects the wire harness to the built-in main body ECU (multiplex network body ECU).
Standard Resistance:
Text in Illustration
NG -- REPLACE INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY
OK -- Continue to next step.
2. CHECK HARNESS OR CONNECTOR
(a) Disconnect the T2 connector.
(b) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Text in Illustration
NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR
OK -- Continue to next step.
3. CHECK HARNESS AND CONNECTOR
(a) Measure the voltage according to the value(s) in the table below.
Standard Voltage:
(b) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Text in Illustration
NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR
OK -- Continue to next step.
4. REPLACE SLIDING ROOF DRIVE GEAR SUB-ASSEMBLY
(a) Replace the sliding roof drive gear assembly Removal.
NEXT -- Continue to next step.
5. CHECK DTC OUTPUT
(a) Clear the DTC Reading and Clearing Diagnostic Trouble Codes.
(b) Recheck for DTCs.
OK:
DTC B1273 is not output.
NG -- REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) Removal
OK -- END (SLIDING ROOF DRIVE GEAR ASSEMBLY WAS DEFECTIVE)