Operation CHARM: Car repair manuals for everyone.

Up to 08/2009





NAVIGATION / MULTI INFO DISPLAY: NAVIGATION SYSTEM (for DVD): B15D8: Monitor Disconnected
B15D8 - Monitor Disconnected

DESCRIPTION

The display and navigation module display and parking assist ECU are connected by the AVC-LAN communication line.

When an AVC-LAN communication error occurs between the display and navigation module display and parking assist ECU, this DTC will be stored.





HINT
* Even if no fault is present, this DTC may be stored depending on the battery condition or engine start voltage.
* The display and navigation module display is the master unit.
WIRING DIAGRAM





INSPECTION PROCEDURE

PROCEDURE

1. CHECK OPTIONAL COMPONENTS (INCLUDING ASSOCIATED WIRING)

(a) Check for optional components.

(1) Check that optional components (including associated wiring) which generate radio waves are not installed.

Result:





HINT
* Electrical noise from radio waves generated by optional components or the wiring for those components may affect AVC-LAN communication.
* This DTC may be stored when an AVC-LAN communication error occurs due to electrical noise.
B -- CHECK DTC
A -- Continue to next step.

2. REMOVE OPTIONAL COMPONENTS

(a) Remove optional components (including associated wiring).

NOTICE:
Do not remove optional components or associated wiring without the permission of the customer.

NEXT -- Continue to next step.

3. CHECK DTC

(a) Clear the DTCs Navigation System (for DVD).

(b) Recheck for DTCs and check if the same DTC is output again.

OK:

No DTCs are output.

NG -- CHECK HARNESS AND CONNECTOR (PARKING ASSIST ECU POWER SOURCE)

OK -- END

4. CHECK HARNESS AND CONNECTOR (PARKING ASSIST ECU POWER SOURCE)

(a) Disconnect the parking assist ECU connector.





(b) Measure the resistance according to the value(s) in the table below.

Standard Resistance:





(c) Measure the voltage according to the value(s) in the table below.

Standard Voltage:





Text in Illustration





NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR
OK -- Continue to next step.

5. CHECK HARNESS AND CONNECTOR (AVC-LAN COMMUNICATION LINE)

(a) Disconnect the parking assist ECU connector.





(b) Disconnect the display and navigation module display connector.





(c) Measure the resistance according to the value(s) in the table below.

Standard Resistance:





Text in Illustration





NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR
OK -- Continue to next step.

6. REPLACE PARKING ASSIST ECU

(a) Replace the parking assist ECU Removal.

(b) Clear the DTCs Navigation System (for DVD).

(c) Recheck for DTCs and check if the same DTC is output again.

OK:

No DTCs are output.

NG -- REPLACE DISPLAY AND NAVIGATION MODULE DISPLAY Removal

OK -- END