Up to 08/2009
SUPPLEMENTAL RESTRAINT SYSTEMS: AIRBAG SYSTEM: B1620/21: Side Airbag Sensor RH Circuit Malfunction
B1620/21 - Side Airbag Sensor RH Circuit Malfunction
DESCRIPTION
The side airbag sensor RH circuit consists of the center airbag sensor assembly, side airbag sensor RH and rear airbag sensor RH.
The side airbag sensor RH and rear airbag sensor RH detect impacts to the vehicle and send signals to the center airbag sensor assembly to determine if the airbag should be deployed.
DTC B1620/21 is recorded when a malfunction is detected in the side airbag sensor RH.
WIRING DIAGRAM
INSPECTION PROCEDURE
PROCEDURE
1. CHECK SIDE AIRBAG SENSOR RH
(a) Turn the engine switch off.
(b) Disconnect the cable from the negative (-) battery terminal.
NOTICE:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
(c) Interchange the side airbag sensor LH with RH and connect the connectors.
(d) Connect the cable to the negative (-) battery terminal.
(e) Turn the engine switch on (IG), and wait for at least 60 seconds.
(f) Clear the DTCs stored in the memory DTC Check / Clear.
(g) Turn the engine switch off.
(h) Turn the engine switch on (IG), and wait for at least 60 seconds.
(i) Check for DTCs DTC Check / Clear.
Result:
Text in Illustration
HINT
Codes other than DTC B1620/21 and B1625/22 may be output at this time, but they are not related to this check.
C -- REPLACE CENTER AIRBAG SENSOR ASSEMBLY Removal
B -- REPLACE SIDE AIRBAG SENSOR RH
A -- USE SIMULATION METHOD TO CHECK How To Proceed With Troubleshooting