Up to 08/2009
SUPPLEMENTAL RESTRAINT SYSTEMS: OCCUPANT CLASSIFICATION SYSTEM: B1794: Open in Occupant Classification ECU Battery Positive Line
B1794 - Open in Occupant Classification ECU Battery Positive Line
DESCRIPTION
DTC B1794 is set when a malfunction is detected in the occupant classification ECU.
HINT
* When DTC B1650/32 is detected as a result of troubleshooting the supplemental restraint system, perform troubleshooting for DTC B1794 of the occupant classification system.
* Use the Techstream to check for DTCs of the occupant classification ECU, otherwise the DTCs cannot be read.
WIRING DIAGRAM
INSPECTION PROCEDURE
NOTICE:
Inspect the fuses for circuits related to this system before performing the following inspection procedure.
PROCEDURE
1. CHECK BATTERY
(a) Measure the voltage of the battery.
Standard Voltage:
11 to 14 V
NG -- REPLACE BATTERY
OK -- Continue to next step.
2. CHECK WIRE HARNESS (SOURCE VOLTAGE)
(a) Turn the engine switch off.
(b) Disconnect the cable from the negative (-) battery terminal.
(c) Disconnect the connector from the occupant classification ECU.
(d) Connect the cable to the negative (-) battery terminal.
(e) Turn the engine switch on (IG).
(f) Measure the voltage according to the value(s) in the table below.
Standard Voltage:
(g) Turn the engine switch off.
(h) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Text in Illustration
NG -- REPLACE WIRE HARNESS
OK -- Continue to next step.
3. CHECK DTC
(a) Turn the engine switch off.
(b) Disconnect the cable from the negative (-) battery terminal.
(c) Connect the connector to the occupant classification ECU.
(d) Connect the Techstream to the DLC3.
(e) Connect the cable to the negative (-) battery terminal.
(f) Turn the engine switch on (IG).
(g) Clear the DTCs stored in the occupant classification ECU Reading and Clearing Diagnostic Trouble Codes.
(h) Clear the DTCs stored in the center airbag sensor assembly DTC Check / Clear.
(i) Turn the engine switch off.
(j) Turn the engine switch on (IG), and wait for at least 10 seconds.
(k) Using the Techstream, check for DTCs of the occupant classification ECU Reading and Clearing Diagnostic Trouble Codes.
OK:
DTC B1794 is not output.
HINT
Codes other than DTC B1794 may be output at this time, but they are not related to this check.
NG -- REPLACE OCCUPANT CLASSIFICATION ECU
OK -- USE SIMULATION METHOD TO CHECK How To Proceed With Troubleshooting
4. REPLACE OCCUPANT CLASSIFICATION ECU
(a) Turn the engine switch off.
(b) Disconnect the cable from the negative (-) battery terminal.
(c) Replace the occupant classification ECU Removal.
NEXT -- Continue to next step.
5. PERFORM ZERO POINT CALIBRATION
(a) Connect the cable to the negative (-) battery terminal.
(b) Connect the Techstream to the DLC3.
(c) Turn the engine switch on (IG).
(d) Using the Techstream, perform the Zero Point Calibration Programming and Relearning.
OK:
"Zero Point Calibration is complete." is displayed.
NEXT -- Continue to next step.
6. PERFORM SENSITIVITY CHECK
(a) Using the Techstream, perform Sensitivity Check Programming and Relearning.
Standard:
27 to 33 kg (59.5 to 72.8 lb)
NEXT -- END