Up to 08/2009

SUPPLEMENTAL RESTRAINT SYSTEMS: OCCUPANT CLASSIFICATION SYSTEM: B1795: Occupant Classification ECU Malfunction
B1795 - Occupant Classification ECU Malfunction

DESCRIPTION

DTC B1795 is stored when a malfunction is detected in the occupant classification ECU.

Troubleshoot DTC B1771 first if DTCs B1771 and B1795 are output simultaneously.





HINT
When DTC B1650/32 is detected as a result of troubleshooting for the airbag system, check the DTCs stored in the occupant classification ECU. When DTC B1795 is output, perform troubleshooting for the DTC.

INSPECTION PROCEDURE

PROCEDURE

1. CHECK DTC

(a) Turn the engine switch on (IG), and wait for at least 10 seconds.

(b) Check for DTCs Reading and Clearing Diagnostic Trouble Codes.

Result:

A
DTCs B1771 and B1795 are output.

B
DTC B1795 is output.

HINT
Codes other than DTCs B1771 and B1795 may be output at this time, but they are not related to this check.

A -- GO TO DTC B1771 Up to 08/2009

B -- Continue to next step.

2. REPLACE OCCUPANT CLASSIFICATION ECU

(a) Turn the engine switch off.

(b) Disconnect the cable from the negative (-) battery terminal.

(c) Replace the occupant classification ECU Removal.

NEXT -- Continue to next step.

3. PERFORM ZERO POINT CALIBRATION

(a) Connect the cable to the negative (-) battery terminal.

(b) Connect the Techstream to the DLC3.

(c) Turn the engine switch on (IG).

(d) Using the Techstream, perform Zero Point Calibration Programming and Relearning.

OK:

"Zero Point Calibration is complete." is displayed.

NEXT -- Continue to next step.

4. PERFORM SENSITIVITY CHECK

(a) Using the Techstream, perform Sensitivity Check Programming and Relearning.

Standard:

27 to 33 kg (59.5 to 72.8 lb)

NEXT -- END