Up to 08/2009
STEERING COLUMN: POWER TILT AND POWER TELESCOPIC STEERING COLUMN SYSTEM: B2603: Tilt and Telescopic Manual Switch Circuit Malfunction
B2603 - Tilt and Telescopic Manual Switch Circuit Malfunction
DESCRIPTION
Different voltage values are input to the multiplex tilt and telescopic ECU by operating the tilt and telescopic switch. The multiplex tilt and telescopic ECU then judges which motor and in which direction that motor should be moved based on the voltage value.
WIRING DIAGRAM
INSPECTION PROCEDURE
PROCEDURE
1. READ VALUE USING TECHSTREAM (TILT UP/DOWN SWITCH, TELESCOPIC SHORT/LONG SWITCH)
(a) Turn the engine switch off.
(b) Connect the Techstream to the DLC3.
(c) Turn the engine switch on (IG).
(d) Turn the Techstream on.
(e) Check the tilt and telescopic manual switch. Enter the following menus: Body Electrical / Tilt & Telescopic / Data List.
Tilt & Telescopic
OK:
"ON" is displayed on the Techstream screen when each switch is turned on.
"OFF" is displayed on the Techstream screen when each switch is turned off.
NG -- CHECK HARNESS AND CONNECTOR (MULTIPLEX TILT AND TELESCOPIC ECU - TILT AND TELESCOPIC SWITCH)
OK -- Continue to next step.
2. CONFIRM DTC
(a) Clear the DTC Power Tilt and Power Telescopic Steering Column System.
(b) Check for DTCs Power Tilt and Power Telescopic Steering Column System.
Result
B -- USE SIMULATION METHOD TO CHECK How To Proceed With Troubleshooting
A -- REPLACE MULTIPLEX TILT AND TELESCOPIC ECU
3. CHECK HARNESS AND CONNECTOR (MULTIPLEX TILT AND TELESCOPIC ECU - TILT AND TELESCOPIC SWITCH)
(a) Disconnect the F36 multiplex tilt and telescopic ECU connector.
(b) Disconnect the F39 headlight dimmer switch assembly connector.
(c) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Text in Illustration
NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR
OK -- Continue to next step.
4. CHECK MULTIPLEX TILT AND TELESCOPIC ECU (VC TERMINAL VOLTAGE)
(a) Reconnect the F36 multiplex tilt and telescopic ECU connector.
(b) Measure the voltage according to the value(s) in the table below.
Standard Voltage:
Text in Illustration
NG -- REPLACE MULTIPLEX TILT AND TELESCOPIC ECU
OK -- Continue to next step.
5. CHECK TILT AND TELESCOPIC SWITCH
(a) Remove the tilt and telescopic switch Removal.
(b) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Text in Illustration
NG -- REPLACE TILT AND TELESCOPIC SWITCH Removal
OK -- REPLACE HEADLIGHT DIMMER SWITCH ASSEMBLY