Up to 08/2009
NETWORKING: LIN COMMUNICATION SYSTEM: B2786: No Response from Steering Lock ECU
B2786 - No Response from Steering Lock ECU
DESCRIPTION
This DTC is stored when LIN communication between the certification ECU (smart key ECU assembly) and steering lock ECU (steering lock actuator assembly) stops for more than 10 seconds.
WIRING DIAGRAM
INSPECTION PROCEDURE
NOTICE:
* If the certification ECU (smart key ECU assembly) is replaced, register the key.
* If the steering lock ECU (steering lock actuator assembly) is replaced, register the ECU code.
* When using the Techstream to troubleshoot with the engine switch off:
* Connect the Techstream to the DLC3, and turn the courtesy switch on and off at 1.5-second intervals until communication between the Techstream and vehicle begins.
PROCEDURE
1. CHECK HARNESS AND CONNECTOR (STEERING LOCK ECU - BATTERY AND BODY GROUND)
(a) Disconnect the F37 connector.
(b) Measure the resistance and voltage according to the value(s) in the table below.
Standard Resistance:
Standard Voltage:
Text in Illustration
NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR, OR REPLACE FUSE
OK -- Continue to next step.
2. CHECK HARNESS AND CONNECTOR (CERTIFICATION ECU - STEERING LOCK ECU)
(a) Disconnect the F58 connector.
(b) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Text in Illustration
NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR
OK -- Continue to next step.
3. REPLACE STEERING LOCK ECU (STEERING LOCK ACTUATOR ASSEMBLY)
(a) Replace the steering lock ECU (steering lock actuator assembly) Disassembly.
NEXT -- Continue to next step.
4. CHECK DTC OUTPUT
(a) Clear the DTC Reading and Clearing Diagnostic Trouble Codes.
(b) Recheck for DTCs.
OK:
DTC B2786 is not output.
NG -- REPLACE CERTIFICATION ECU (SMART KEY ECU ASSEMBLY)
OK -- END (STEERING LOCK ECU WAS DEFECTIVE)