Up to 08/2009
THEFT DETERRENT / KEYLESS ENTRY: ENGINE IMMOBILISER SYSTEM: B2799: Engine Immobiliser System Malfunction
B2799 - Engine Immobiliser System Malfunction
DESCRIPTION
This DTC is stored when one of the following occurs: 1) the ECM detects an error in its own communication with the ID code box (immobiliser code ECU); 2) the ECM detects an error in the communication lines; or 3) the ECU communication ID between the ID code box (immobiliser code ECU) and ECM is different and an engine start is attempted.
HINT
Before troubleshooting this DTC, make sure that no certification ECU (smart key ECU assembly) DTCs are present. If present, troubleshoot the certification ECU (smart key ECU assembly) DTCs first.
WIRING DIAGRAM
INSPECTION PROCEDURE
NOTICE:
If the ID code box (immobiliser code ECU) is replaced, register the ECU code and ECU communication ID Engine Immobilizer System.
PROCEDURE
1. CHECK DTC OUTPUT
(a) Clear the DTCs Engine Immobiliser System.
(b) Recheck for DTCs Engine Immobiliser System.
OK:
DTC B2799 is not output.
NG -- RE-REGISTER ECU COMMUNICATION ID
OK -- USE SIMULATION METHOD TO CHECK How To Proceed With Troubleshooting
2. RE-REGISTER ECU COMMUNICATION ID
(a) Re-register the ECU communication ID Engine Immobilizer System.
NEXT -- Continue to next step.
3. CHECK DTC OUTPUT
(a) Clear the DTCs Engine Immobiliser System.
(b) Recheck for DTCs Engine Immobiliser System.
OK:
DTC B2799 is not output.
NG -- CHECK CONNECTOR CONNECTION CONDITION
OK -- END (ECU COMMUNICATION ID WAS NOT REGISTERED CORRECTLY)
4. CHECK CONNECTOR CONNECTION CONDITION
(a) Turn the engine switch off.
(b) Check that the connectors are properly connected to the ECM and ID code box (immobiliser code ECU).
OK:
Connectors are properly connected.
NG -- CONNECT CONNECTORS PROPERLY
OK -- Continue to next step.
5. CHECK HARNESS AND CONNECTOR (ID CODE BOX - ECM)
(a) Disconnect the ID code box (immobiliser code ECU) connector.
(b) Disconnect the ECM connector.
(c) Measure the resistance and voltage according to the value(s) in the table below.
Standard Resistance:
Standard Voltage:
Text in Illustration
NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR
OK -- Continue to next step.
6. REPLACE ECM
(a) Replace the ECM Removal.
NEXT -- Continue to next step.
7. CHECK DTC OUTPUT
(a) Clear the DTCs Engine Immobiliser System.
(b) Recheck for DTCs Engine Immobiliser System.
OK:
DTC B2799 is not output.
NG -- REPLACE ID CODE BOX (IMMOBILISER CODE ECU) Removal
OK -- END (ECM WAS DEFECTIVE)