Operation CHARM: Car repair manuals for everyone.

Up to 08/2009





POWER ASSIST SYSTEMS: POWER STEERING SYSTEM: C1552: PIG Power Supply Voltage Malfunction


DESCRIPTION

If a problem occurs in the power steering system, the power source relay circuit is shut off to stop the power assist.





WIRING DIAGRAM





INSPECTION PROCEDURE

NOTICE:
- If the power steering ECU has been replaced with a new one, perform the rotation angle sensor initialization and torque sensor zero point calibration Programming and Relearning.
- Inspect the fuses for circuits related to this system before performing the following inspection procedure.
PROCEDURE

1. READ VALUE USING TECHSTREAM (PIG POWER SUPPLY)

(a) Turn the engine switch off.

(b) Connect the Techstream to the DLC3.

(c) Turn the engine switch on (IG).

(d) Turn the Techstream on.

(e) Enter the following menus: Chassis / EMPS / Data List.

(f) Select the item "PIG Power Supply" in the Data List and read the value displayed on the Techstream.

EMPS





OK:

The normal condition value is displayed on the Techstream.

NG -- CHECK HARNESS AND CONNECTOR (POWER STEERING ECU - BATTERY AND BODY GROUND)

OK -- REPLACE POWER STEERING ECU Removal

2. CHECK HARNESS AND CONNECTOR (POWER STEERING ECU - BATTERY AND BODY GROUND)

(a) Disconnect the connector from the power steering ECU.





(b) Measure the voltage according to the value(s) in the table below.

Standard Voltage:





(c) Measure the resistance according to the value(s) in the table below.

Standard Resistance:





Text in Illustration





NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR

OK -- REPLACE POWER STEERING ECU Removal