Up to 08/2009
SUSPENSION CONTROL: AIR SUSPENSION SYSTEM: C1789: Vehicle Identification Malfunction
C1789 - Vehicle Identification Malfunction
DESCRIPTION
- This DTC is stored when the suspension control ECU is initialized, and is cleared when the vehicle identification information received through CAN communication is correctly stored in the EEPROM.
- DTC C1789 is stored as the vehicle specification and data do not match when an incorrect ECM is installed.
INSPECTION PROCEDURE
NOTICE:
- Before performing troubleshooting, inspect the connectors of related circuits.
- If DTC C1782 (Power Source Voltage Malfunction) is output at the same time, perform troubleshooting for C1782 first C1782.
- Before replacing the suspension control ECU, perform all of the following again: 1) symptom simulation How To Proceed With Troubleshooting; 2) DTC inspection Reading and Clearing Diagnostic Trouble Codes; and 3) Techstream inspection (Data List or Active Test) Scan Tool Testing and Procedures. If no malfunctions are found in other areas, replace the suspension control ECU.
- If the suspension control ECU is replaced, the vehicle height offset calibration and registration of vehicle identification information must be performed Calibration and Registration)
PROCEDURE
1. CHECK DTC (C1781)
(a) Check for DTC C1781 Reading and Clearing Diagnostic Trouble Codes
Result:
B -- REPLACE SUSPENSION CONTROL ECU
A -- Continue to next step.
2. REGISTRATION OF VEHICLE IDENTIFICATION INFORMATION
(a) Perform registration of vehicle identification information Registration
NEXT -- Continue to next step.
3. CHECK DTC (C1789)
(a) Check for DTC C1789 Reading and Clearing Diagnostic Trouble Codes
Result:
B -- CHECK CAN COMMUNICATION SYSTEM
A -- END
1. CHECK CAN COMMUNICATION SYSTEM
(a) Check the CAN communication system for any malfunctions Diagnosis System.
Result:
B -- GO TO CAN COMMUNICATION SYSTEM How to Proceed With Troubleshooting
A -- Continue to next step.
2. CHECK ECM
(a) Check if the part number of the installed ECM is correct.
OK:
An ECM with the correct part number is installed.
NG -- REPLACE ECM Removal
OK -- REPLACE SUSPENSION CONTROL ECU