Operation CHARM: Car repair manuals for everyone.

Up to 08/2009





CRUISE CONTROL: DYNAMIC RADAR CRUISE CONTROL SYSTEM: P1572: Improper Aiming of Radar Sensor Beam Axis
P1572 - Improper Aiming of Radar Sensor Beam Axis

DESCRIPTION

This DTC is output when the scanning angle of the millimeter wave radar sensor is incorrect. This DTC is also output when the millimeter wave radar sensor beam axis is determined to be in an incorrect position.





INSPECTION PROCEDURE

NOTICE:
When the millimeter wave radar sensor is replaced with a new one, adjustment of the radar sensor beam axis must be performed Adjustments.

PROCEDURE

1. ADJUST MILLIMETER WAVE RADAR SENSOR

(a) Adjust the millimeter wave radar sensor Adjustments.

NEXT -- Continue to next step.

2. CHECK DTC

(a) Clear the DTCs Dynamic Radar Cruise Control System.

(b) Perform the following to make sure that the DTC detection conditions are met.

HINT
If the detection conditions are not met, the malfunction cannot be detected.

(1) Drive the vehicle at a speed of 50 km/h (31 mph) or more.

(2) Turn the cruise control main switch on.

(c) Check for DTCs Dynamic Radar Cruise Control System.

Result:





B -- REPLACE MILLIMETER WAVE RADAR SENSOR Components

A -- END