Up to 08/2009

PRE-COLLISION: PRE-COLLISION SYSTEM: U1104: Lost Communication with Driving Support ECU
U1104 - Lost Communication with Driving Support ECU

DESCRIPTION

The driving support ECU sends vehicle speed and vehicle condition information to the millimeter wave radar sensor. The millimeter wave radar sensor then sends information on the presence, distance, and relative speed of objects ahead to the driving support ECU. The driving support ECU sends this information to the ECM and performs cruise control.





WIRING DIAGRAM





INSPECTION PROCEDURE

NOTICE:
* When replacing the millimeter wave radar sensor with a new one, make sure to perform Adjust Millimeter Wave Radar Sensor Assembly Adjustments.
* Confirm that the connector is securely connected, as a partially connected connector is suspected for the cause of this DTC.
PROCEDURE

1. CHECK HARNESS AND CONNECTOR (DRIVING SUPPORT ECU - MILLIMETER WAVE RADAR SENSOR)

(a) Disconnect the driving support ECU and millimeter wave radar sensor connectors.





(b) Measure the resistance according to the value(s) in the table below.

Standard Resistance:





Text in Illustration





(c) Reconnect the driving support ECU and millimeter wave radar sensor connectors.

NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR (DRIVING SUPPORT ECU - MILLIMETER WAVE RADAR SENSOR)
OK -- Continue to next step.

2. CHECK MILLIMETER WAVE RADAR SENSOR (IGB VOLTAGE)

(a) Disconnect the millimeter wave radar sensor connector.





(b) Turn the engine switch on (IG).

(c) Measure the voltage according to the value(s) in the table below.

Standard Voltage:





Text in Illustration





(d) Reconnect the millimeter wave radar sensor connector.

NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR (IGB CIRCUIT)
OK -- Continue to next step.

3. CHECK MILLIMETER WAVE RADAR SENSOR (SGND CIRCUIT)

(a) Disconnect the millimeter wave radar sensor connector.





(b) Measure the resistance according to the value(s) in the table below.

Standard Resistance:





Text in Illustration





(c) Reconnect the millimeter wave radar sensor connector.

NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR (SGND CIRCUIT)
OK -- Continue to next step.

4. CHECK DRIVING SUPPORT ECU (LRRD OUTPUT VOLTAGE)

(a) Turn the engine switch on (IG).





(b) Measure the voltage according to the value(s) in the table below.

Standard Voltage:





Text in Illustration





NG -- REPLACE DRIVING SUPPORT ECU Removal
OK -- Continue to next step.

5. REPLACE MILLIMETER WAVE RADAR SENSOR

(a) Replace the millimeter wave radar sensor Removal.

(b) Adjust the millimeter wave radar sensor Adjustments.

NEXT -- Continue to next step.

6. CHECK DTC OUTPUT

(a) Clear the DTCs Pre-Collision System.

(b) Turn the cruise control main switch on.

(c) Drive the vehicle at the required speed (27 mph (45 km/h) or higher).

(d) Check if the same DTC is output Pre-Collision System.

Result:





B -- REPLACE DRIVING SUPPORT ECU Removal

A -- END