Up to 08/2009

NETWORKING: CAN COMMUNICATION SYSTEM: U110B,U1110: Lost Communication with Parking Assist Control Module "B"
U1110 - Lost Communication with Clearance Sonar Module

DESCRIPTION

HINT
The parking assist ECU includes the clearance sonar module (w/ parking assist monitor and intuitive parking assist system).

WIRING DIAGRAM

INSPECTION PROCEDURE

NOTICE:
* Turn the engine switch off before measuring the resistances between CAN bus main wires and between CAN bus branch wires.
* Turn the engine switch off before inspecting CAN bus wires for a ground short.
* After the engine switch is turned off, check that the key reminder warning system and light reminder warning system are not operating.
* Before measuring the resistance, leave the vehicle as is for at least 1 minute and do not operate the engine switch, any other switches or the doors. If any doors need to be opened in order to check connectors, open the doors and leave them open.
HINT
* Operating the engine switch, any other switches or a door triggers related ECU and sensor communication on the CAN. This communication will cause the resistance value to change.
* Even after DTCs are cleared, if a DTC is stored again after driving the vehicle for a while, the malfunction may be occurring due to vibration of the vehicle. In such a case, wiggling the ECUs or wire harness while performing the inspection below may help determine the cause of the malfunction.
PROCEDURE

1. RECONFIRM DTC OUTPUT

(a) Reconfirm DTCs.

HINT
If CAN No. 2 bus DTC U1002 is output from the power management control ECU (Techstream display/Power Management1), troubleshoot for U1002 and check for malfunctions in the CAN No. 2 main bus circuit.

Result:

B -- GO TO CIRCUITS INDICATED BY OUTPUT DTCS U1002
A -- Continue to next step.

2. CHECK CAN BUS WIRE FOR DISCONNECTION (PARKING ASSIST ECU BRANCH WIRE)

(a) Turn the engine switch off.

(b) Disconnect the parking assist ECU connector.

Text in Illustration

NG -- REPAIR OR REPLACE CAN BUS BRANCH WIRE OR CONNECTOR (PARKING ASSIST ECU BRANCH WIRE)
OK -- Continue to next step.

3. CHECK HARNESS AND CONNECTOR (POWER SOURCE TERMINAL)

(a) Measure the voltage according to the value(s) in the table below.

Standard Voltage:

Text in Illustration

NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR (POWER SOURCE CIRCUIT)
OK -- Continue to next step.

4. CHECK HARNESS AND CONNECTOR (GROUND TERMINAL)

(a) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Text in Illustration

NG -- HARNESS OR CONNECTOR (GROUND CIRCUIT)

OK -- REPLACE PARKING ASSIST ECU Removal