Operation CHARM: Car repair manuals for everyone.

Pre-Collision System





PRE-COLLISION: PRE-COLLISION SYSTEM: TERMINALS OF ECU

1. CHECK SEAT BELT CONTROL ECU





(a) Disconnect the seat belt control ECU connectors.

(b) Measure the resistance and voltage according to the value(s) in the table below.





(b) If the result is not as specified, there may be a malfunction on the wire harness side.

(c) Reconnect the connectors.

(d) Measure the voltage according to the value(s) in the table below.





(d) If the result is not as specified, the ECU may be malfunctioning.

2. CHECK DRIVING SUPPORT ECU





(a) Disconnect the driving support ECU connector.

(b) Measure the voltage and resistance according to the value(s) in the table below.





(c) Connect the driving support ECU connector.

(d) Turn the engine switch on (IG).

(e) Measure the voltage according to the value(s) in the table below.





(e) If the result is not as specified, there may be a malfunction on the wire harness side.