Up to 08/2009

NAVIGATION / MULTI INFO DISPLAY: NAVIGATION SYSTEM (for DVD): Current Position Display does not Appear
- Current Position Display does not Appear

INSPECTION PROCEDURE

PROCEDURE

1. CHECK MULTI-MEDIA MODULE NAVIGATION ASSEMBLY

(a) Display the "Information" screen and select "Map Data".





(b) Check if a disc is inserted into the map disc slot.





(1) Check if the map data version is displayed in the "Map Data" section.

OK:

The map data version is displayed.

NG -- INSERT MAP DISC IN MAP SIDE SLOT
OK -- Continue to next step.

1. CHECK MAP DISC

(a) Check that the map disc is not deformed or cracked.





OK:

No deformations or cracks on the map disc

NG -- REPLACE MAP DISC
OK -- Continue to next step.

1. CHECK CABIN

(a) Check that condensation is not likely to occur in the cabin, and that the temperature is not high or extremely low in the cabin.

HINT
* A humid cabin and a rapid change in temperature may lead to condensation. Condensation in the cabin may cause a short circuit.
* The navigation system may not operate normally when the temperature is -20°C (-4°F) or lower, or 65°C (149°F) or higher.

OK:

Condensation is not likely being produced and the temperature is not high or extremely low.

NG -- CABIN TO APPROPRIATE TEMPERATURE

OK -- PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE Problem Symptoms Table