Up to 08/2009
MIRROR (EXT): OUTER REAR VIEW MIRROR: REMOVAL
1. PRECAUTION (w/ Navigation System for HDD)
NOTICE:
After the engine switch is turned off, the display and navigation module display (HDD navigation system) records various types of memory and settings. As a result, after turning the engine switch off, make sure to wait at least 60 seconds before disconnecting the cable from the negative (-) battery terminal.
2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.
3. REMOVE FRONT DOOR INSIDE HANDLE BEZEL PLUG Disassembly
4. REMOVE POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Driver Side) Disassembly
5. REMOVE POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Front Passenger Side) Removal
6. REMOVE DOOR ARMREST COVER Disassembly
7. REMOVE COURTESY LIGHT ASSEMBLY Removal
8. REMOVE NO. 1 FRONT DOOR STIFFENER CUSHION Disassembly
9. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY Disassembly
10. REMOVE FRONT DOOR INNER GLASS WEATHERSTRIP Disassembly
11. REMOVE DOOR FRAME GARNISH Disassembly
12. REMOVE FRONT NO. 3 SPEAKER ASSEMBLY Removal
13. REMOVE OUTER MIRROR CONTROL ECU ASSEMBLY Removal
14. REMOVE NO. 1 FRONT DOOR TRIM BRACKET Disassembly
15. REMOVE FRONT DOOR SERVICE HOLE COVER Disassembly
16. REMOVE OUTER MIRROR PROTECTOR
(a) Remove the outer mirror protector.
17. REMOVE OUTER MIRROR INSTALL HOLE COVER
(a) Using a moulding remover, disengage the 2 claws and 2 guides, and remove the outer mirror install hole cover.
Text in Illustration
18. REMOVE OUTER REAR VIEW MIRROR ASSEMBLY
(a) w/o Side Monitor System:
(1) Disengage the clamp as shown in the illustration.
(2) Remove the 3 nuts.
(b) w/ Side Monitor System:
(1) Disconnect the connector.
(2) Disengage the clamp as shown in the illustration.
(3) Remove the 3 nuts.
(c) Disengage the claw and remove the outer rear view mirror assembly as shown in the illustration.
