Up to 08/2009

MF1A TRANSFER / 4WD / AWD: 4WD CONTROL ECU: INSTALLATION

1. INSTALL 4WD ECU ASSEMBLY

(a) Connect the connector.





(b) Install the 4WD ECU assembly with the bolt.

Torque : 8.5 Nm (87 kgf-cm, 75 in-lbf)

2. INSTALL GLOVE COMPARTMENT DOOR ASSEMBLY Installation

3. INSTALL FRONT PASSENGER SIDE KNEE AIRBAG ASSEMBLY Installation

4. INSTALL INSTRUMENT PANEL GARNISH RH Installation

5. INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY Installation

6. INSTALL COWL SIDE TRIM SUB-ASSEMBLY RH Installation

7. INSTALL FRONT DOOR SCUFF PLATE RH Installation

8. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL Installation

9. INSTALL UPPER CONSOLE PANEL SUB-ASSEMBLY Installation

10. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY Installation

11. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
* Make sure that the cable has been disconnected from the negative (-) battery terminal for at least 2 seconds before reconnecting the cable.
* When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.
12. INSPECT SRS WARNING LIGHT

(a) Inspect the SRS warning light Diagnosis System.