Up to 08/2009

TIRE PRESSURE MONITORING: TIRE PRESSURE WARNING RECEIVER: INSTALLATION

1. INSTALL TIRE PRESSURE WARNING RECEIVER

(a) Connect the connector.





(b) Engage the 2 tabs into the holes as shown in the illustration to install the tire pressure warning receiver.





(c) Install the bolt.

Torque : 5.0 Nm (51 kgf-cm, 44 in-lbf)

2. INSTALL ROOF HEADLINING ASSEMBLY

HINT
Refer to the procedures from "Install roof headlining assembly" Installation.

3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

4. INSPECT TIRE PRESSURE WARNING SYSTEM

(a) Inspect the tire pressure warning system Test Mode Procedure.