Up to 08/2009

SUPPLEMENTAL RESTRAINT SYSTEMS: CURTAIN SHIELD AIRBAG ASSEMBLY: INSTALLATION

1. INSTALL CURTAIN SHIELD AIRBAG ASSEMBLY

HINT
* Use the same procedure for the RH side and LH side.
* The procedure listed below is for the LH side.
(a) Check that the engine switch is off.

(b) Check that the cable is disconnected from the negative (-) battery terminal.

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

(c) Temporarily install the curtain shield airbag assembly with the 10 hooks.





NOTICE:
Do not twist the curtain shield airbag assembly when installing it.

(d) Install the 10 bolts.

Torque : 14 Nm (140 kgf-cm, 10 ft-lbf)

(e) Connect the curtain shield airbag connector.

NOTICE:
When connecting the airbag connector, take care not to damage the airbag wire harness.

2. INSTALL ROOF HEADLINING ASSEMBLY

HINT
Refer to the procedure from Install Roof Headlining Assembly Installation.

3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

4. PERFORM DIAGNOSTIC SYSTEM CHECK

(a) Perform a diagnostic system check DTC Check / Clear.

5. INSPECT SRS WARNING LIGHT

(a) Inspect the SRS warning light Diagnosis System.