Up to 08/2009

SUPPLEMENTAL RESTRAINT SYSTEMS: FRONT PASSENGER AIRBAG ASSEMBLY: INSTALLATION

1. INSTALL INSTRUMENT PANEL WIRE ASSEMBLY

(a) Connect the 2 airbag connectors.





NOTICE:
* When connecting any airbag connector, take care not to damage the airbag wire harness.
* Be sure to only connect the connectors to each corresponding color.
(b) Push in the lock to install the airbag connector.

(c) Engage the clamp to install the instrument panel wire assembly to the front passenger airbag assembly.

2. INSTALL FRONT PASSENGER AIRBAG ASSEMBLY

(a) Engage the 5 hooks.





(b) Push the front passenger airbag assembly to engage the 5 hooks.





(c) Engage the 2 pins.

(d) Install the 2 screws to install the front passenger airbag assembly.

Text in Illustration





3. INSTALL INSTRUMENT PANEL SAFETY PAD ASSEMBLY Installation

4. CONNECT INSTRUMENT PANEL WIRE ASSEMBLY

(a) Check that the engine switch is off.

(b) Check that the cable is disconnected from the negative (-) battery terminal.

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

(c) Connect the connector.





NOTICE:
When connecting the airbag connector, take care not to damage the airbag wire harness.

5. INSTALL NO. 1 CONSOLE BOX DUCT

HINT
Refer to the procedure from Install No. 1 Console Box Duct Installation.

6. PERFORM DIAGNOSTIC SYSTEM CHECK

(a) Perform a diagnostic system check DTC Check / Clear.