Up to 08/2009

SUPPLEMENTAL RESTRAINT SYSTEMS: CENTER AIRBAG SENSOR ASSEMBLY: INSTALLATION

1. INSTALL CENTER AIRBAG SENSOR ASSEMBLY

(a) Check that the engine switch is off.

(b) Check that the cable is disconnected from the negative (-) battery terminal.

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

(c) Using SST and a torque wrench, install the center airbag sensor assembly with the 3 bolts.





Text in Illustration





SST : 09961-00950

without SST - Torque : 18 Nm (178 kgf-cm, 13 ft-lbf)

with SST - Torque : 11 Nm (112 kgf-cm, 8 ft-lbf)

NOTICE:
* Use a torque wrench with a fulcrum length of 250 mm (9.84 in.).
* This torque value is effective when SST is parallel to a torque wrench.
* If the center airbag sensor assembly has been dropped, or there are any cracks, dents or other defects in the case or connector, replace it with a new one.
* When installing the center airbag sensor assembly, be careful that the SRS wiring does not interfere with or is not pinched between other parts.
* When the engine switch is first turned on (IG) after the center airbag sensor assembly has been replaced, make sure that no one is in the vehicle.
(d) Connect the connector to the center airbag sensor assembly as shown in the illustration.

NOTICE:
When connecting the airbag connector, take care not to damage the airbag wire harness.

(e) Check that the waterproof sheet is properly set.

(f) Check that there is no looseness in the installation parts of the center airbag sensor assembly.

2. INSTALL CONSOLE BOX Installation

3. INSTALL REAR CONSOLE BOX ASSEMBLY Installation

4. INSTALL MULTI-MEDIA INTERFACE ECU ASSEMBLY (w/ USB Audio System) Installation

5. INSTALL CONSOLE REAR END PANEL SUB-ASSEMBLY Installation

6. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL Installation

7. INSTALL INSTRUMENT PANEL FINISH PANEL Installation

8. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY Installation

9. INSTALL NO. 1 SWITCH HOLE BASE Installation

10. INSTALL INSTRUMENT PANEL GARNISH LH Installation

11. INSTALL NO. 2 CONSOLE BOX DUCT Installation

12. INSTALL UPPER CONSOLE PANEL SUB-ASSEMBLY Installation

13. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY Installation

14. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

15. DIAGNOSTIC SYSTEM CHECK

(a) Perform a diagnostic system check DTC Check / Clear.

16. INSPECT SRS WARNING LIGHT

(a) Inspect the SRS warning light Diagnosis System.

17. INSPECT SUSPENSION CONTROL SYSTEM

(a) Inspect the suspension control system Test Mode Procedure.