Up to 08/2009

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS: YAW RATE AND ACCELERATION SENSOR: REMOVAL

1. PRECAUTION (w/ Navigation System for HDD)

NOTICE:
After the engine switch is turned off, the display and navigation module display (HDD navigation system) records various types of memory and settings. As a result, after turning the engine switch off, make sure to wait at least 60 seconds before disconnecting the cable from the negative (-) battery terminal.

2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

3. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY Removal

4. REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY Removal

5. REMOVE NO. 2 CONSOLE BOX DUCT Removal

6. REMOVE CONSOLE REAR END PANEL SUB-ASSEMBLY Removal

7. REMOVE MULTI-MEDIA INTERFACE ECU ASSEMBLY (w/ USB Audio System) Removal

8. REMOVE REAR CONSOLE BOX ASSEMBLY Removal

9. REMOVE FRONT DOOR SCUFF PLATE LH Removal

10. REMOVE COWL SIDE TRIM SUB-ASSEMBLY LH Removal

11. REMOVE INSTRUMENT PANEL GARNISH LH Removal

12. REMOVE NO. 1 SWITCH HOLE BASE Removal

13. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY Removal

14. REMOVE INSTRUMENT PANEL FINISH PANEL Removal

15. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL Removal

16. REMOVE CONSOLE BOX Removal

17. REMOVE YAW RATE AND ACCELERATION SENSOR

(a) Disconnect the connector from the yaw rate and acceleration sensor.





(b) Remove the 2 bolts and yaw rate and acceleration sensor.

NOTICE:
Do not remove the installation nuts.