Four Wheel Drive Selector Switch: Testing and Inspection

MF1A TRANSFER / 4WD / AWD: 4WD CONTROL SWITCH: INSPECTION

1. INSPECT 4 WHEEL DRIVE CONTROL SWITCH

(a) Measure the resistance according to the value(s) in the table below.





Standard Resistance:





(b) If the result is not as specified, replace the 4 wheel drive control switch.

Text in Illustration





(c) Apply battery voltage between the terminals of the switch, and check the illumination condition of the engine switch.

HINT
* If a positive (+) battery lead and a negative (-) battery lead are incorrectly connected, the engine switch indicator light will not illuminate.
* If the voltage is too low, the indicator light will not illuminate.

OK:





(d) If the result is not as specified, replace the 4 wheel drive control switch.