Part 3

61. REMOVE FRONT PLANETARY GEAR ASSEMBLY

(a) Using SST and a press, remove the planetary gear assembly from the transaxle case.





SST : 09950-60010

09951-00580

SST : 09950-70010

09951-07100

62. REMOVE COUNTER DRIVE GEAR

NOTICE:
Perform this procedure only when the counter drive gear bearing or transaxle case is replaced.

(a) Using SST and a press, remove the counter drive gear and bearing inner race (rear side) from the transaxle case.





SST : 09950-60020

09951-00710

SST : 09950-70010

09951-07100

(b) As shown in the illustration, tighten the 3 bolts evenly and leave a clearance of approximately 20.0 mm (0.787 in.) between the counter drive gear and bearing inner race (front side).





(c) Using SST, remove the bearing inner race (front side) from the counter drive gear.





Text in Illustration





SST : 09950-00020

SST : 09950-00030

SST : 09950-60020

09951-00710

63. REMOVE NO. 3 BRAKE PISTON

(a) Using a screwdriver, remove the snap ring from the transaxle case.





(b) Remove the brake piston return spring from the transaxle case.





Text in Illustration





(c) Remove the No. 3 brake piston from the transaxle case.

Text in Illustration





64. REMOVE MANUAL DETENT SPRING SUB-ASSEMBLY

(a) Remove the bolt, cover and manual detent spring sub-assembly from the transaxle case.





65. REMOVE PARKING LOCK ROD SUB-ASSEMBLY

(a) Remove the parking lock rod sub-assembly from the parking lock lever sub-assembly.





HINT
Align the slot with the notches on the parking lock lever sub-assembly to remove the parking lock rod sub-assembly.

66. REMOVE MANUAL VALVE LEVER SHAFT

(a) Using needle-nose pliers, remove the manual valve lever shaft retainer spring from the transaxle case.





(b) Using a screwdriver, slide the spacer of the manual valve lever sub-assembly.





(c) Using a pin punch (3 mm) and hammer, drive out the slotted spring pin from the manual valve lever sub-assembly.





HINT
To prevent the pin from falling into the case, drive the pin until it has cleared the manual valve lever shaft.

(d) Using a screwdriver, slide the spacer of the parking lock lever sub-assembly.





(e) Using a pin punch (3 mm) and hammer, drive out the slotted spring pin from the parking lock lever sub-assembly.





HINT
To prevent the pin from falling into the case, drive the pin until it has cleared the manual valve lever shaft.

(f) Remove the manual valve lever shaft, manual valve lever sub-assembly, parking lock lever sub-assembly and 2 spacers from the transaxle case.





67. REMOVE MANUAL VALVE LEVER SHAFT OIL SEAL

(a) Using a screwdriver, remove the manual valve lever shaft oil seal from the transaxle case.