Up to 08/2009
U660E AUTOMATIC TRANSMISSION / TRANSAXLE: TRANSMISSION CONTROL CABLE: INSTALLATION
1. INSTALL TRANSMISSION CONTROL CABLE ASSEMBLY
NOTICE:
Before installing the transmission control cable assembly, check that the park/neutral position switch and the shift lever are in neutral.
(a) Pass the control cable from the cabin to the engine compartment.
(b) Install the transmission control cable assembly with the 3 bolts.
Torque : 5.0 Nm (51 kgf-cm, 44 in-lbf)
(c) Connect the transmission control cable to the clamp.
(d) Install a new clip to the control cable bracket.
(e) Install the control cable to the control cable bracket.
Text in Illustration
NOTICE:
* Make sure that the claws A on the clip are securely fit into the bracket holes.
* Make sure that the cable is securely installed inside of the claws B of the clip.
(f) Connect the transmission control cable to the control shaft lever with the nut.
Torque : 12 Nm (122 kgf-cm, 9 ft-lbf)
NOTICE:
Before connecting the transmission control cable assembly, check that the park/neutral position switch and the shift lever are in neutral.
2. INSTALL AIR CLEANER ASSEMBLY Installation
3. INSTALL INLET NO. 1 AIR CLEANER Installation
4. INSTALL INLET NO. 2 AIR CLEANER Installation
5. INSTALL V-BANK COVER SUB-ASSEMBLY Installation
6. INSTALL BATTERY Installation
7. INSTALL INSTRUMENT PANEL REINFORCEMENT ASSEMBLY WITH AIR CONDITIONING UNIT ASSEMBLY
HINT
See the steps from "Install Instrument Panel Reinforcement Assembly with Air Conditioning Unit Assembly" through "Inspect SRS Warning Light" Installation.
8. INSPECT SHIFT LEVER POSITION U660E Automatic Transaxle
9. ADJUST SHIFT LEVER POSITION U660E Automatic Transaxle