Up to 08/2009

U660E AUTOMATIC TRANSMISSION / TRANSAXLE: SHIFT LEVER: INSTALLATION

1. INSTALL SHIFT LEVER ASSEMBLY

NOTICE:
Check that the park/neutral position switch and the shift lever are in neutral.

(a) Slide the slider of the transmission control cable in the direction indicated by the arrow and pull the lock piece outward.

Text in Illustration

(b) Turn the lock nut of the transmission control cable counterclockwise. While holding the lock nut, push in the stopper.

Text in Illustration

NOTICE:
The lock nut is fully seated against the shift lever retainer.

(d) Install the transmission control cable end to the shift lever assembly.

Text in Illustration

NOTICE:
* Check that the lock piece is pulled up.
* Install the cable end all the way to the base of the pin.
(e) Install the shift lever assembly with the 4 nuts.

Torque : 12 Nm (122 kgf-cm, 9 ft-lbf)

(f) Connect the 3 clamps to the shift lever assembly.

(g) Connect the 2 connectors.

(h) Push the lock piece into the adjuster case.

NOTICE:
* Check that the park/neutral position switch and the shift lever are in neutral.
* Securely push in the lock piece until the slider lock is engaged.
2. INSTALL CONSOLE BOX Installation

3. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL Installation

4. INSTALL INSTRUMENT PANEL FINISH PANEL Installation

5. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY Installation

6. INSTALL NO. 1 SWITCH HOLE BASE Installation

7. INSTALL INSTRUMENT PANEL GARNISH LH Installation

8. INSTALL REAR CONSOLE BOX ASSEMBLY Installation

9. INSTALL MULTI-MEDIA INTERFACE ECU ASSEMBLY (w/ USB Audio System) Installation

10. INSTALL CONSOLE REAR END PANEL SUB-ASSEMBLY Installation

11. INSTALL NO. 2 CONSOLE BOX DUCT Installation

12. INSTALL UPPER CONSOLE PANEL SUB-ASSEMBLY Installation

13. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY Installation

14. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

15. INSPECT SUSPENSION CONTROL SYSTEM (w/ Air Suspension)

(a) Inspect the suspension control system Test Mode Procedure.

16. INSPECT SHIFT LEVER POSITION U660E Automatic Transaxle

17. ADJUST SHIFT LEVER POSITION U660E Automatic Transaxle