From 08/2009

WINDOW / GLASS: POWER WINDOW REGULATOR MOTOR (for Front Door): REMOVAL

HINT
* Use the same procedure for the RH side and LH side.
* The procedure listed below is for the LH side.
1. PRECAUTION

NOTICE:
After the engine switch is turned off, the display and navigation module display (HDD navigation system) records various types of memory and settings. As a result, after turning the engine switch off, make sure to wait at least 60 seconds before disconnecting the cable from the negative (-) battery terminal.

2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system Service Precautions.

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

3. REMOVE FRONT DOOR INSIDE HANDLE BEZEL PLUG Disassembly

4. REMOVE POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Driver Side) Disassembly

5. REMOVE POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Front Passenger Side) Removal

6. REMOVE DOOR ARMREST COVER Disassembly

7. REMOVE COURTESY LIGHT ASSEMBLY Removal

8. REMOVE NO. 1 FRONT DOOR STIFFENER CUSHION Disassembly

9. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY Disassembly

10. REMOVE FRONT DOOR INNER GLASS WEATHERSTRIP Disassembly

11. REMOVE DOOR SIDE AIR BAG SENSOR Removal

12. REMOVE FRONT NO. 3 SPEAKER ASSEMBLY Removal

13. REMOVE NO. 1 FRONT DOOR TRIM BRACKET Disassembly

14. REMOVE FRONT DOOR SERVICE HOLE COVER Disassembly

15. REMOVE FRONT DOOR GLASS SUB-ASSEMBLY Disassembly

16. REMOVE FRONT DOOR WINDOW REGULATOR ASSEMBLY Disassembly

17. REMOVE FRONT POWER WINDOW REGULATOR MOTOR ASSEMBLY

(a) Using a T25 "TORX" driver, remove the 3 screws and the front power window regulator motor assembly.