Up to 08/2009

WIPER / WASHER: WIPER AND WASHER SYSTEM: Washer Signal Circuit
- Washer Signal Circuit

DESCRIPTION

The headlight cleaner control relay receives the windshield washer operation signal.

WIRING DIAGRAM





INSPECTION PROCEDURE

PROCEDURE

1. CHECK OPERATION

(a) Check the operation of the front wiper and washer system.

OK:

Front wiper and washer system operates normally.

NG -- GO TO PROBLEM SYMPTOMS TABLE Up to 08/2009

OK -- Continue to next step.

2. CHECK HARNESS AND CONNECTOR (WINDSHIELD WIPER SWITCH ASSEMBLY - RELAY)

(a) Disconnect the A33 headlight cleaner control relay connector.





(b) Measure the voltage according to the value(s) in the table below.

Standard Voltage:





Text in Illustration





NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR

OK -- PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE Up to 08/2009