Up to 08/2009

NETWORKING: LIN COMMUNICATION SYSTEM: B2287: LIN Communication Master Malfunction
B2287 - LIN Communication Master Malfunction

DESCRIPTION

This DTC is stored when there is an open, short or ECU communication malfunction between the power management control ECU and certification ECU (smart key ECU assembly).





WIRING DIAGRAM





INSPECTION PROCEDURE

NOTICE:
* If the certification ECU (smart key ECU assembly) is replaced, register the key.
* When using the Techstream to troubleshoot with the engine switch off:
* Connect the Techstream to the DLC3, and turn the courtesy switch on and off at 1.5-second intervals until communication between the Techstream and vehicle begins.
PROCEDURE

1. CHECK DTC OUTPUT

(a) Clear the DTC Reading and Clearing Diagnostic Trouble Codes.

(b) Recheck for DTCs.

HINT
Check the both smart access and main body DTCs.

Result:





HINT
When DTC B2287 and B2785 are output simultaneously, perform troubleshooting for DTC B2785 first.

B -- GO TO DTC B2785 Up to 08/2009

A -- Continue to next step.

2. CHECK HARNESS AND CONNECTOR (CERTIFICATION ECU - POWER MANAGEMENT CONTROL ECU)

(a) Disconnect the F8 and F58 connectors.





(b) Measure the resistance according to the value(s) in the table below.

Standard Resistance:





Text in Illustration





NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR
OK -- Continue to next step.

3. REPLACE POWER MANAGEMENT CONTROL ECU

(a) Replace the power management control ECU Removal.

NEXT -- Continue to next step.

4. CHECK DTC OUTPUT

(a) Clear the DTC Reading and Clearing Diagnostic Trouble Codes.

(b) Recheck for DTCs.

OK:

DTC B2287 is not output.

NG -- REPLACE CERTIFICATION ECU (SMART KEY ECU ASSEMBLY) Removal

OK -- END (POWER MANAGEMENT CONTROL ECU WAS DEFECTIVE)