Up to 08/2009

NAVIGATION / MULTI INFO DISPLAY: HARD DISK DRIVE: REMOVAL

1. PRECAUTION

Navigation System (for HDD)

NOTICE:
* After the engine switch is turned off, the display and navigation module display (HDD navigation system) records various types of memory and settings. As a result, after turning the engine switch off, make sure to wait at least 60 seconds before disconnecting the cable from the negative (-) battery terminal.
* A hard disk drive (HDD) is built into the navigation receiver assembly to store map data etc. which will be used for the navigation system. Therefore, make sure to read all of the precautions thoroughly before handling the navigation receiver assembly.
2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

3. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY Removal

4. REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY Removal

5. REMOVE NO. 2 CONSOLE BOX DUCT Removal

6. REMOVE CONSOLE REAR END PANEL SUB-ASSEMBLY Removal

7. REMOVE MULTI-MEDIA INTERFACE ECU ASSEMBLY (w/ USB Audio System) Removal

8. REMOVE REAR CONSOLE BOX ASSEMBLY Removal

9. REMOVE INSTRUMENT PANEL GARNISH LH Removal

10. REMOVE NO. 1 SWITCH HOLE BASE Removal

11. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY Removal

12. REMOVE INSTRUMENT PANEL FINISH PANEL Removal

13. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL Removal

14. REMOVE RADIO RECEIVER ASSEMBLY WITH REGISTER Removal

15. REMOVE CONSOLE BOX Removal

16. REMOVE SHIFT LEVER ASSEMBLY Removal

17. REMOVE DISPLAY AND NAVIGATION MODULE DISPLAY WITH BRACKET Removal

18. REMOVE HARD DISK DRIVE

(a) Remove the 2 screws.





(b) Using a screwdriver with its tip wrapped with protective tape, remove the hard disk drive as shown in the illustration.





Text in Illustration