Up to 08/2009

2GR-FE ENGINE CONTROL: CAMSHAFT OIL CONTROL VALVE: INSTALLATION

1. INSTALL CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY

(a) Apply a light coat of engine oil to 4 new O-rings and install them to the 4 camshaft timing oil control valve assemblies.





Text in Illustration





(b) Install the 4 oil control valves with the 4 bolts.





Torque : 10 Nm (102 kgf-cm, 7 ft-lbf)

NOTICE:
Make sure that each O-ring is not cracked or does not jump out of position during installation.

(c) Connect the 4 oil control valve connectors.

(d) Install the bolt and connect the wire harness clamp to install the engine wire.





Torque : 14 Nm (138 kgf-cm, 10 ft-lbf)

2. INSTALL INTAKE AIR SURGE TANK ASSEMBLY Installation

3. INSTALL AIR CLEANER ASSEMBLY Installation

4. INSTALL NO. 1 AIR CLEANER INLET Installation

5. INSTALL NO. 2 AIR CLEANER INLET Installation

6. INSTALL BATTERY Installation

7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

8. ADD ENGINE COOLANT Service and Repair

9. INSPECT FOR ENGINE COOLANT LEAK Testing and Inspection

10. INSPECT FOR OIL LEAK

(a) Start the engine, and check that there are no oil leaks.

11. INSTALL V-BANK COVER SUB-ASSEMBLY Installation

12. INSTALL OUTER COWL TOP PANEL SUB-ASSEMBLY Installation

13. INSTALL FRONT SHOCK ABSORBER CAP (w/ Air Suspension) Installation

14. INSTALL WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY

(a) Install the windshield wiper motor and link assembly Installation.

15. INSTALL NO. 1 ENGINE UNDER COVER