Up to 08/2009

WIPER / WASHER: WIPER SWITCH: INSTALLATION

1. INSTALL WINDSHIELD WIPER SWITCH ASSEMBLY

(a) Engage the claw and install the windshield wiper switch assembly as shown in the illustration.

(b) Connect the connector.

2. INSTALL STEERING COLUMN COVER (for TMC Made)

(a) Engage the 2 guides and the 4 clips as shown in the illustration.

(b) Engage the claw.

NOTICE:
Do not damage the tilt and telescopic switch.

(d) Install the screw.

(e) Turn the steering wheel assembly to the left and install the screw as shown in the illustration.

(f) Turn the steering wheel assembly to the right and install the screw as shown in the illustration.

(g) Make sure that the cable has been disconnected from the battery terminal for at least 2 seconds before reconnecting the cable.

(h) Connect the cable to the negative (-) battery terminal with the front wheels facing straight ahead.

(i) Reset the auto tilt away function setting to the previous condition by changing the customize parameter Programming and Relearning.

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

3. INSTALL UPPER STEERING COLUMN COVER (for TMMC Made)

(a) Engage the 2 guides and the 4 clips as shown in the illustration.

(b) Engage the claw to install the upper steering column cover.

4. INSTALL LOWER STEERING COLUMN COVER (for TMMC Made)

(a) Engage the 2 claws to install the lower steering column cover.

NOTICE:
Do not damage the tilt and telescopic switch.

(b) Install the screw.

(c) Turn the steering wheel assembly to the left and install the screw as shown in the illustration.

(d) Turn the steering wheel assembly to the right and install the screw as shown in the illustration.

(e) Make sure that the cable has been disconnected from the battery terminal for at least 2 seconds before reconnecting the cable.

(f) Connect the cable to the negative (-) battery terminal with the front wheels facing straight ahead.

(g) Reset the auto tilt away function setting to the previous condition by changing the customize parameter Programming and Relearning.

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.