Reassembly
STEERING GEAR / LINKAGE: STEERING GEAR: REASSEMBLY
1. INSTALL NO. 2 STEERING RACK BOOT
(a) Apply lithium soap base glycol grease to the inside of the small opening of a new No. 2 steering rack boot.
(b) Install the No. 2 steering rack boot to the groove on the rack housing.
NOTICE:
* Be careful not to damage or twist the boot.
* Make sure that the boot is free of rust and foreign matter.
2. INSTALL NO. 1 STEERING RACK BOOT
HINT
Perform the same procedure as for the LH side.
3. INSTALL STEERING RACK BOOT RETAINER (for LH Side)
(a) Using SST, tighten a new steering rack boot retainer, as shown in the illustration.
SST : 09521-24010
Clearance:
3.0 mm (0.118 in.) or less
NOTICE:
Be careful not to damage the No. 2 steering rack boot.
4. INSTALL STEERING RACK BOOT RETAINER (for RH Side)
HINT
Perform the same procedure as for the LH side.
SST : 09521-24010
5. INSTALL STEERING RACK BOOT CLIP (for LH Side)
(a) Using pliers, install the steering rack boot clip.
6. INSTALL STEERING RACK BOOT CLIP (for RH Side)
HINT
Perform the same procedure as for the LH side.
7. INSPECT STEERING GEAR ASSEMBLY
(a) Using SST, rotate the pinion shaft to see if both the left and the right steering rack boots expand and contract smoothly.
SST : 09616-00020
HINT
If the operation cannot be done as specified, use a new steering rack boot retainer and reinstall the steering rack boots.