Up to 08/2009

WINDOW / GLASS: POWER WINDOW REGULATOR MOTOR (for Rear Door): REMOVAL

NOTICE:
* Use the same procedure for the RH side and LH side.
* The procedure listed below is for the LH side.
1. PRECAUTION

NOTICE:
After the engine switch is turned off, the display and navigation module display (HDD navigation system) records various types of memory and settings. As a result, after turning the engine switch off, make sure to wait at least 60 seconds before disconnecting the cable from the negative (-) battery terminal.

2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

3. REMOVE REAR DOOR INSIDE HANDLE BEZEL PLUG Disassembly

4. REMOVE REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE PANEL Disassembly

5. REMOVE REAR DOOR ARMREST COVER Disassembly

6. REMOVE COURTESY LIGHT ASSEMBLY Removal

7. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY Disassembly

8. REMOVE REAR DOOR INNER GLASS WEATHERSTRIP Disassembly

9. REMOVE REAR DOOR FRAME GARNISH Disassembly

10. REMOVE REAR DOOR TRIM BRACKET Disassembly

11. REMOVE REAR DOOR SERVICE HOLE COVER Disassembly

12. REMOVE REAR DOOR GLASS RUN Disassembly

13. REMOVE REAR DOOR WINDOW REAR GUIDE SUB-ASSEMBLY Disassembly

14. REMOVE REAR DOOR REAR GUIDE SEAL Disassembly

15. REMOVE REAR DOOR GLASS SUB-ASSEMBLY Disassembly

16. REMOVE REAR DOOR WINDOW REGULATOR ASSEMBLY Disassembly

17. REMOVE REAR POWER WINDOW REGULATOR MOTOR ASSEMBLY

(a) Using a T25 "TORX" socket wrench, remove the 3 screws and the rear power window regulator motor assembly.