Up to 08/2009

NAVIGATION / MULTI INFO DISPLAY: NAVIGATION RECEIVER (for HDD): INSTALLATION

1. INSTALL DISPLAY AND NAVIGATION MODULE DISPLAY

2. INSTALL NO. 4 DISC PLAYER BRACKET

(a) Install the No. 4 disc player bracket with the 2 bolts.





3. INSTALL NO. 3 DISC PLAYER BRACKET

(a) Install the No. 3 disc player bracket with the 2 bolts.





4. INSTALL HARD DISK DRIVE Installation

5. INSTALL DISPLAY AND NAVIGATION MODULE DISPLAY WITH BRACKET

(a) Connect each connector.

(b) Install the display and navigation module display with bracket as shown in the illustration.





6. INSTALL SHIFT LEVER ASSEMBLY Installation

7. INSTALL CONSOLE BOX Installation

8. INSTALL RADIO RECEIVER ASSEMBLY WITH REGISTER Installation

9. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL Installation

10. INSTALL INSTRUMENT PANEL FINISH PANEL Installation

11. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY Installation

12. INSTALL NO. 1 SWITCH HOLE BASE Installation

13. INSTALL INSTRUMENT PANEL GARNISH LH Installation

14. INSTALL REAR CONSOLE BOX ASSEMBLY Installation

15. INSTALL MULTI-MEDIA INTERFACE ECU ASSEMBLY (w/ USB Audio System) Installation

16. INSTALL CONSOLE REAR END PANEL SUB-ASSEMBLY Installation

17. INSTALL NO. 2 CONSOLE BOX DUCT Installation

18. INSTALL UPPER CONSOLE PANEL SUB-ASSEMBLY Installation

19. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY Installation

20. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

CAUTION:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

21. INSTALL REAR DECK FLOOR BOX Installation

22. INSPECT SHIFT LEVER POSITION Adjustments

23. ADJUST SHIFT LEVER POSITION Adjustments

24. INSPECT SUSPENSION CONTROL SYSTEM (w/ Air Suspension)

(a) Inspect the suspension control system Test Mode Procedure.